Siemens FS20 - 6 Planning Housings and Mechanical Components; Housing for Wall Mounting

Planning housings and mechanical components
Housing for wall mounting
6
50 | 242
Building Technologies
008843_v_en_
--
Fire Safety
2015
-
12
-
15
6 Planning housings and mechanical
components
6.1 Housing for wall mounting
The housing for wall mounting of the ↑ stations is comprised of the following
components:
● Rear panel
● Operating unit
● Cover cap
The electronic components and the batteries are built in the rear panel. The
operating unit is mounted to the rear panel so that it is can be pivoted. The cover
cap, together with the operating unit, acts as a cover.
The table below shows the housings available for the wall mounting:
FH2001-A1
(Eco)
FH2002-A1
(Standard)
FH2003-A1
(Comfort)
FH2005-A1
(Large)
FH2004-A1
(Large
Extension)
Dimensions (mm)
Width 430 430 430 430 430
Height 398 398 796 796 398
Depth (rear
panel)
80 160 160 260 260
Depth (total) 103 183 183 283 283
Max. battery
capacity
(housing empty)
2 x 7 Ah 2 x 17 Ah 2 x 26 Ah 2 x 65 Ah
1
2 x 65 Ah
1
Typical
application
FT2040
FT2080
FC2020
Optional
extensions
FC2020
FC2030
FC2040
FC2060
FC2040 [SE], [FI],
[DE]
Optional
extensions
Table 8: Housing overview
1
Limited to 65 Ah due to the weight.