Siemens FS20 - Page 63

Planning detector lines
Planning an FDnet detector
line
7
63 |
242
Building Technologies
008843_v_en_
--
Fire Safety
2015
-
12
-
15
Device type Type Description AI EAI FDSB291
Linear smoke detector FDL241-9
Linear smoke detector for demanding
applications with many deceptive
phenomena
X X –
Manual call point FDM221 Direct activation for indoor applications X – –
FDM223
FDM223H
Indirect activation (large housing) X X –
FDM224
FDM224H
Indirect activation (large housing) X X –
FDM225 Direct activation for indoor applications X – –
FDM226 Direct activation for outdoor applications X – –
FDM231
Direct activation with small housing for
indoor applications
X – –
FDM233
Indirect activation, suitable for migration
from existing SIGMASYS systems to
Sinteso systems
X – –
FDM234
Direct activation, suitable for migration
from existing SIGMASYS systems to
Sinteso systems
X – –
FDM243H
Indirect activation, robust housing for
use outdoors and in humid rooms,
suitable for migration from existing
SIGMASYS systems to Sinteso systems
X – –
Input module FDCI221 1 potential-free contact input X – –
FDCI222 4 potential-free contact inputs X – –
Zone module FDCI223
Zone module for connecting to
conventional fire detectors, with safety
barrier (SB3) for areas at risk of
explosion.
X – –
Input/output module FDCIO221
1 potential-free contact input and 1
monitored control output for any
controls
X – –
FDCIO222
4 potential-free contact inputs and 4
control outputs for any controls
X – –
FDCIO223
2 inputs/outputs can be alternatively
used either for controlling sounders,
connecting ↑ collective detector lines,
or as a monitored contact input. Mixed
operation with 1 input channel and 1
output channel is also possible.
This requires an electrically isolated
24 V supply in all cases.
X – –
FDCIO224
4 potential-free contact inputs and 4
control outputs for the connection of the
VdS extinguishing interface in
compliance with the ↑ VdS or
realization of fire controls in compliance
with EN 54
X – –