EasyManua.ls Logo

Siemens FS20 - Page 96

Siemens FS20
242 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Planning detector lines
Interactive Ex detector line
7
96 | 242
Building Technologies
008843_v_en_
--
Fire Safety
2015
-
-
15
Supported Ex detectors
The line card (interactive, Ex) supports the same recording peripheral equipment
as the corresponding AlgoRex line plug-in module E3M171.
DOT multi-sensor smoke detectors: DOT1151A-Ex above SB3
DT heat detectors: DT1151A-Ex above SB3
DF flame detectors: DF1151-Ex above SB3
DM manual call points: DM115x-Ex above SB3
Additional documentation
You will find detailed information on the line card (interactive, Ex) in the
008837 product data.
You will find detailed information on device compatibility in the 'List of
compatibility'.
You will find detailed information on interactive Ex line devices in
document 1204 'Fire alarm signal in areas at risk of explosion'.
You will find information on key detector figures in AlgoRex document 001508
'Guidelines'.
You will find information on modernization and migration in documents
A6V10323158 'Modernizing fire detection installations with multiple protocol
detectors' and 009078 Configuration, chapter 'AlgoRex/SIGMASYS data
migration'.
You will find information about configuration and commissioning in
documents 009052 and 009078.
See chapter 'Applicable documents'.

Table of Contents

Other manuals for Siemens FS20

Related product manuals