16.In the Task commands command bar, select the command Start task.
This inserts the command.
17.In the Important commands command bar, select the command Variable assignment.
This inserts the command.
18.Double-click the Start task command.
19.Click OK to confirm.
20.Double-click the Variable assignment command.
21.Enter the statement Run:=false.
Figure A-7 Configuration of the variable assignment
Appendix
A.2 Creating an example program for axis positioning in SIMOTION SCOUT
SIMOTION SCOUT
232 Configuration Manual, 11/2016
To Next Page
Loading...
Need help?
General
