Siemens SINUMERIK 808D ADVANCED - Page 216

Programming and Operating Manual (Milling)
216 6FC5398-4DP10-0BA1, 01/2014
; Ready to start next program or repeat
N455 M30
Subroutine name: SUB_PART_3
Subroutine content:
G17 G90
G0 X7 Y0
G1 Y61.35
G2 X13.499 Y86 I=AC(57) J=AC(61.35)
G1 X63 RND=2
Y0
M2;/* end of contour */
Programming example 3
N10 G17 G90 G54 G60 ROT
N20 T1 D1; FACEMILL
N30 M6
N40 S4000 M3 M8
N50 G0 X-40 Y0
N60 G0 Z2
N70 CYCLE71( 50.00000, 1.00000, 2.00000, 0.00000, -25.00000, -25.00000, 50.00000,
50.00000, 0.00000, 1.00000, , ,0.00000, 400.00000, 11, )
N80 S4500
N90 CYCLE71( 50.00000, 1.00000, 2.00000, 0.00000, -25.00000, -25.00000, 50.00000,
50.00000, 0.00000, 1.00000, , ,0.00000, 400.00000, 32, )
N100 G0 Z100
N110 T2 D1 ; ENDMILL D8
N120 M6
N130 S4000 M3
N140 M8 G0 X-13 Y16
N150 G0 Z2
_ANF:
N160 POCKET3( 50.00000, 0.00000, 2.00000, -5.00000, 13.00000, 10.00000, 4.00000, -
13.00000, 16.00000, 0.00000, 5.00000, 0.10000, 0.10000, 300.00000, 200.00000, 2, 11,
2.50000, , , ,2.00000, 2.00000)
AROT Z90
_END:
REPEAT _ANF _END P=3