Siemens SINUMERIK 808D ADVANCED - Page 262

Programming and Operating Manual (Milling)
262 6FC5398-4DP10-0BA1, 01/2014
Address
Significance
Value assignments
Information
Programming
G71 * Metric dimension data input
input, modally effective
G700 Inch dimension data input; also for
feedrate F
G710 Metric dimension data input; also for
feedrate F
G90 * Absolute dimension data input 14: Absolute/incremental
dimension, modally effective
G91 Incremental dimension data input
G94 * Feed F in mm/min 15: Feedrate/spindle, modally
effective
G95 Feedrate F in mm/spindle revolutions
CFC * Feedrate override with circle ON 16: Feed override, modally
effective
CFTCP Feedrate override OFF
G450 * Transition circle 18: Behavior at corners when
working with tool radius
compensation, modally
effective
G451 Point of intersection
BRISK * Jerking path acceleration 21: Acceleration profile,
modally effective
SOFT Jerk-limited path acceleration
FFWOF * Feedforward control OFF 24: Feedforward control,
modally effective
FFWON Feedforward control ON
EXTCALL Execute external subprogram Reload program from HMI in
"Execution from external
source" mode.
G340 * Approach and retraction in space (SAR) 44: Path segmentation with
SAR, modally effective
G341 Approach and retraction in the plane (SAR)
G290 * SIEMENS mode 47: External NC languages,
modally effective
G291 External mode
H
H0=
to
H9999=
H function ± 0.0000001 ...
9999 9999
(8 decimal places)
or with specification
of an exponent:
± (10
-300
... 10
+300
)
Value transfer to the PLC;
meaning defined by the
machine manufacturer
H0=... H9999=...
e.g.: H7=23.456
I Interpolation
parameters
±0.001 ... 99
999.999
Thread:
0.001 ... 2000.000
Belongs to the X axis;
meaning dependent on G2,
G3 ->circle center or G33,
G331, G332 -> thread pitch
See G2, G3, G33, G331 and
G332
J Interpolation
parameters
±0.001 ... 99
999.999
Thread:
0.001 ... 2000.000
Belongs to the Y axis;
otherwise, as with I
See G2, G3, G33, G331, and
G332
K Interpolation
parameters
±0.001 ... 99
999.999
Thread:
0.001 ... 2000.000
Belongs to the Z axis;
otherwise, as with I
See G2, G3, G33, G331, and
G332
I1= Intermediate point
for circular
interpolation
±0.001 ... 99
999.999
Belongs to the X axis;
specification for circular
interpolation with CIP
See CIP
J1= Intermediate point
for circular
interpolation
±0.001 ... 99
999.999
Belongs to the Y axis;
specification for circular
interpolation with CIP
See CIP
K1= Intermediate point
for circular
interpolation
±0.001 ... 99
999.999
Belongs to the Z axis;
specification for circular
interpolation with CIP
See CIP