1-36 280C-009-002 REV B www.stryker.com
Return To Table of Contents
English
THIGH SECTION REPLACEMENT
Tools Required:
• Needle Nose Pliers
• 1/2” Combination Wrench
• #2 Phillips Screwdriver
Procedure:
Note
Unless otherwise indicated, refer to Figure 6 (page 1-35) for this procedure.
1. Raise the bed to the highest position and apply the brakes. Flatten all sections of the mattress support.
2. Unplug the power cord from the wall receptacle.
3. Raise the siderails.
4. Using needle nose pliers, remove the rue ring cotter/washers/clevis pin (E, Figure 8, page 1-40) linking the thigh
section lever arms to the thigh actuator tube.
5. Using a 1/2” combination wrench, remove the four locknuts, four washers, four shoulder spacers, and four bolts (B,
C) linking the thigh section to the foot and seat sections.
6. Remove the defective thigh section and lay it upside down on a workbench.
7. Using a #2 Phillips screwdriver, remove the two screws (D) holding the micro switch activator to the thigh section.
Install the micro switch activator on the new thigh section.
8. Reverse the above steps to install the new thigh section.
Note
Apply grease on the clevis pin and nylon washers before joining the foot section to the actuator tube.
9. Test the Gatch as well as the Auto Contour positioning (optional) before returning the bed to service.
Note
Check the positioning of the switch activator on the thigh section if Auto Contour (option) does not operate properly.
Service Information
To Next Page
Loading...
Need help?
General
