1-64 280C-009-002 REV B www.stryker.com
Return To Table of Contents
English
STEER WHEEL ASSEMBLY REPLACEMENT
Tools Required:
• 1/2” Combination Wrench
• Soft Hammer
Procedure:
Note
Unless otherwise indicated, refer to Figure 18, page 1-62, for this procedure.
1. Raise the bed to the highest position.
2. Unplug the power cord from the wall receptacle.
3. Remove the optional steer wheel hood.
Note
When reinstalling the steer wheel hood, ensure the colored labels affixed to the hood and the brake/steer pedal match.
4. Position the brake/steer pedal to neutral.
5. Using a 1/2” combination wrench, remove the two nuts, two shoulder spacers, two washers, and two bolts (C1, C2,
Figure 19, page 1-66) holding the brake rods to the locking levers on both sides of the mechanism. If the optional
four-wheel brake system is present on the bed, also remove the fasteners holding the two other brake rods to the
locking levers.
6. Using a 1/2” combination wrench, remove the two bolts (A) holding each side of the steer wheel mechanism to the
base. Keep the molded spacers (B). Remove the assembly.
7. Using a soft hammer, remove the two brake/steer pedals from the activation lever shafts.
8. Keep the two locking levers (D, Figure 19, page 1-66).
9. Reverse the above steps to install the new steer wheel assembly.
10. Test the steer wheel before returning the bed to service.
Service Information
To Next Page
Loading...
Need help?
General
