Stryker GoBed II - Brake;Steer Pedal Replacement

1-62 280C-009-002 REV B www.stryker.com
Return To Table of Contents
English
BRAKE/STEER PEDAL REPLACEMENT
Tools Required:
• 1/2” Combination Wrench
• Soft Hammer
Procedure:
1. Raise the bed to the highest position.
2. Unplug the power cord from the wall receptacle.
3. Remove the optional steer wheel hood.
Note
When reinstalling the steer wheel hood, ensure the colored labels affixed to the hood match the brake/steer pedal.
4. Position the brake/steer pedal to neutral.
5. Using a 1/2” combination wrench, remove the two bolts (A) holding the steer wheel support on the side of the
defective pedal and lay the support down. Keep the molded spacer (B).
6. Using a soft hammer, remove the pedal from the activation lever shaft.
7. Reverse the above steps to install the new pedal.
49
A
B
E
D
D
F
G
F
Figure 18
Service Information