Chapter 5 Maintaining the Workstation 5-59
5.18.2 Resetting Previous BIOS Settings
To set the BIOS for your local environment, perform this procedure after updating
the BIOS.
1. Reboot the system.
2. Press the F2 key to enter the BIOS configuration.
The BIOS Setup screen displays.
3. Make any setting changes you require. In particular, ensure that RAID settings are
enabled if required, and set the OS to the appropriate operating system. For more
information, see the Sun Ultra 20 M2 Workstation Operating System Installation Guide.
4. Press the F10 key to save changes and exit.
To Next Page
Loading...
