4-14 Sun Ultra 20 M2 Workstation Service Manual • January 2007
7. Type the following command:
Where mountpoint is the CD mountpoint and linux_version is the version of Linux
that you installed. For example:
8. Type the following command to install the diagnostic partition:
9. Press the Enter key.
The following lines appear if the diagnostic partition is mounted successfully:
10. Type the following command:
The contents of the diagnostic partition are listed.
4.7.4 Accessing the Diagnostic Partition Under the
Solaris 10 Operating System
Perform this procedure to access the diagnostic partition when you are running the
Solaris 10 Operating System.
1. Remove the Tools and Drivers CD from the DVD drive tray.
2. Reboot the machine and start the Solaris 10 Operating System.
3. Log in as superuser.
# cd mountpoint/drivers/linux/linux_version
# cd /mnt/cdrom/drivers/linux/red_hat
# ./install.sh
Mounting Diagnostic Partition
Installation Successful
# ls /diagpart
To Next Page
Loading...
