Chapter 3 Troubleshooting 3-3
5. Verify that the components are fully seated in their sockets or connectors and that
the sockets are clean.
6. Verify that all cables inside the system are firmly attached to their appropriate
connectors.
7. Replace the left side access panel.
8. Reconnect the system and any attached peripherals to their power sources, and
then power them on.
3.3 Troubleshooting Procedures
TABLE 3-1 contains possible problems that might arise during the use of your
workstation. Possible solutions are listed for each problem. If the solutions listed
here do not fix the problem, run the appropriate diagnostic test (see Chapter 4).
As you work, keep notes in case you need to call Sun technical support:
To Next Page
Loading...
Need help?
General
