5-38 Sun Ultra 20 M2 Workstation Service Manual • January 2007
5.13 Replacing the Power Supply
This section describes removing and installing the power supply.
5.13.1 Removing the Power Supply
Perform this procedure to remove the power supply.
1. Follow the steps in Section 5.2.2, “Powering Off the System and Removing the Left
Side Access Panel” on page 5-3.
2. Unplug the AC power cord from the system.
3. Gently lay the system on its right side on a stable, nonslip surface.
4. Locate the power supply (see
FIGURE 5-25).
FIGURE 5-25 Location of the Power Supply
To Next Page
Loading...
