5-18 Sun Ultra 20 M2 Workstation Service Manual • January 2007
6. Install all hard drives into the hard drive cage.
See Section 5.4.2, “Installing a Hard Disk Drive” on page 5-10.
7. Inspect the storage backplane, cables, and installed HDDs.
■ Be sure that the power cable is seated in the storage backplane.
■ Be sure that the storage interface cables are seated in the storage backplane
connectors.
8. To close the system, perform the steps in Section 5.3.1, “Postinstallation
Instructions” on page 5-5.
To Next Page
Loading...
