182 Sun Server X4-2 Service Manual • May 2014
c. Select Target Port, and then type the target port of the iSCSI server.
For example: 3260 (default target port setting)
Note – When iSCSI is enabled on a network port, PXE is disabled for the port.
d. Select Boot LUN, and then type the hexadecimal representation of the logical
unit number (LUN).
For example: 0
e. Continue to Step 12
11. To set DHCP to enabled, do the following, and then press Enter to save your
changes.
a. Select Enable DHCP setting, and then press the + or - key (plus or minus
key) to change the setting to Enabled.
You do not need to enter the settings for the iSCSI Initiator and the related
fields are hidden.
b. Select Get target info via DHCP, and toggle the setting to Enabled.
The target information is retrieved from the DHCP service and the related fields
are hidden
The following screen shows Enable DHCP and Get target info via
DHCP set to Enabled.
To Next Page
Loading...
