BIOS Setup Utility Menu Options 223
Add an Attempt
(Continued)
• Internet Protocol IP4 Can be set to IP4, IP6, or Autoconfigure. The initiator
IP address is assigned by the system to IP6. In
Autoconfigure mode, the iSCSI driver attempts to
connect to the iSCSI target using the IPv4 stack. If
this fails, then the iSCSI driver attempt to connect
using the IPv6 stack.
• Connection Retry
Count
0 The count range is 0 to 16. If set to 0, there are no
retries.
• Connection
Establishing
Timeout
1,000 The timeout value in milliseconds. The timeout
range is 100 milliseconds to 20 seconds.
• OUI-format ISID
(R/O)
This
valued
derived
from
MAC
address
OUI-format ISID represented in six bytes.
• Configure ISID The last
three
bytes of
the
OUI-for
mat ISID
The default value is derived from the MAC address.
Only this portion of the ISID is configurable.
• Enable DHCP Enabled Enabled or disable.
• Initiator IP
Address
None Use to set the initiator IP address.
• Initiator Subnet
Mask
None Use to set initiator subnet mask address.
• Gateway None Use to set initiator gateway address.
• Target Name Worldwide unique name of the target. Only IQN
format is accepted.
• Target IP address None Use to set target IP address
• Target Port 3260 Use to change target port number.
• Boot LUN 0 Use to set the hexadecimal representation of the boot
logical unit number (LUN).
TABLE: BIOS UEFI Driver Control Menu Options (Continued)
Setup Options Options Default Description
To Next Page
Loading...
