OPERATION & MAINTENANCE MANUAL SWE50E/SWE60E/SWE70E/SWE80E9/SWE100
Travel operation
Do not exceed allowed load of the machine to
prevent damages to it.
When traveling on flat ground, lower work
equipment (bucket) to a height of 400
to500mm above the ground level.
When traveling on slopes, the work equipment
must be lowered to a height of 20 to 30cm
above. If the slope is steep, the work
equipment must be extended accordingly.
When travel on slopes or in a confined area,
cancel auto-idle function as well as to set travel
speed at “LOW” position.
Never change direction on slopes or attempt
upper-structure swing operation.
When passing under bridge, tunnel or other
place with limited height, check to make sure
the machine could pass through. If yes, travel
at low speed.
When the machine travels on bridge or other
place with load limitation, make sure the
weight of the machine do not exceed load
limits.
Always keep safety distance, when traveling
under high voltage cables.
Always keep certain distance away from
people, structure and other objects.
Go pass grassland and marsh at low speed.
Do not immerse the machine in water by more
than the permissible depth (under center of
sprocket).
To Next Page
Loading...
