SUNWARD SWE50E - During Storage; After Storage

OPERATION & MAINTENANCE MANUAL SWE50E/SWE60E/SWE70E/SWE80E9/SWE100
55
2.2.2 During storage
Note
 When it’s necessary to perform the
rust-preventive operation while the
machine is at indoor, open the doors
and windows to ventilate and prevent
gas poisoning.
 During storage, operate the machine to travel,
swing and dig for 2 to 3 cycles at lease once a
month so as to lubricate machine, and charge
the machine battery.
 Before operating, check cooling water level
and lubrication status.
 Air condition must run once a month.
2.2.3 After storage
Note
 Start engine only in well-ventilated
condition.
 Remove lubricating grease on piston rod
surface.
 Apply grease to all lubricating parts.
 Check engine oil level, keep it in specified
level, if not, and refill engine oil. If some water
is found to mix in the oil, replace it.
 Check fuel level and bleed the air.
 Check its level to ensure that it is with the
standard range.
 Start and run the engine at half speed for
several minutes before operation with full load.
 Cycle all hydraulic function for several times.