OPERATION & MAINTENANCE MANUAL SWE50E/SWE60E/SWE70E/SWE80E9/SWE100
3.10.8 Machine traveling
Note
Only if the idler roller is under cab,
the machine moves in the same
direction to the operation of the
travel levers.
When machine is traveling, do not
change traveling direction suddenly
to avoid damages to machine.
When starting the engine, set idle roller under
cab. Then place safety lock lever to ON
position.
Fold work equipment, lift boom, and keep the
bucket at a height of 400 to 500mm above
ground level.
Push travel control lever or step down travel
pedal ： push forward both travel control
lever(or pedal) in sync, the machine will move
forward; pull backward both travel control
lever( or pedal) in sync, the machine will move
in reverse.
The machine present 2 travel speed stage:
high/low speed, 55km/h and 35km/h
accordingly.
When the sprocket is located under cab, push
both travel control lever (or pedal) in sync, the
machine will reverse. Pull backward both 2
lever (or pedal), the machine will travel
forward. .
Note：
In real job, should it’s difficult
to identify the relationship between
machine travel direction and joystick
operate direction due to long-time
operation, you may give a trial operation
by handling joystick slightly. With
direction relationship identified, you
are allowed to proceed to operate.
To Next Page
Loading...
