OPERATION & MAINTENANCE MANUAL SWE50E/SWE60E/SWE70E/SWE80E9/SWE100
(3) Strong heating operation
When it is very cold, especially the period of time after just turning on the heater, it is cold
inside the vehicle or sometimes there is frost, snow which needs removing, you should choose
this operation. That is: choose heating pattern, press “wind speed increasing button” to choose
the highest wind speed, press “set increasing button” to choose the highest temperature.
(4) Weak heating operation
When it is slightly cold, especially the period of time after turning on the heater, the indoor
temperature is suitable or slightly warm, you should choose this operation. That is: choose
heating pattern, press “wind speed decreasing button” to choose the lowest wind speed, press
“set decreasing button” to choose moderately low temperature.
(5) Dehumidification and defrosting operation
When it is damp (including the indoor vapor and sweat made by human) and indoor
temperature is higher than outdoor (including using heater), except the discomfort of dampness
to human, a layer of frost will form on the inner side of the glass which will affect the view.
Now you should choose this operation.
There are two ways of this operation:
a. When it is moderate or slightly hot, choose “weak refrigeration operation” (see ② for
details)
b. When it is slightly cold, choose defrost pattern ( will appear on the screen). At
defrosting pattern, the refrigeration amount is set by the program, it can not be adjusted
and there’s no display; the heating amount can be adjusted by operator according to
requirements of the indoor temperature.
3.8.4 Other instructions
(1) Machine set up: As long as you change the system operation pattern, the system will close
the extrinsic cycle air door automatically (enter internal circulation pattern). If operator has to
use the extrinsic cycle after changing the operation pattern or just start up, press .
(2) The machine will automatically remember any patterns (expect circulation wind pattern) or
the change of set (including automatically remember the condition before shut down when
turning off the machine), when you use this pattern again, the machine will return to the last
condition (including automatically return to the condition before last shut down after start). It’s
very convenient for the users, e.g when start the machine in the afternoon, it will automatically
return to the using condition of the shut down in the morning.
To Next Page
Loading...
