OPERATION & MAINTENANCE MANUAL SWE50E/SWE60E/SWE70E/SWE80E9/SWE100
Stop the engine, remove key from starting
lock, set pilot safety lock lever to LOCK
position.
Check hose for any twist, abrasion, check
hose clamp for looseness or lost. Check
damages of cooler. Check flange for looseness,
and oil leakage.
When clamping, repairing or replacing any
loosened, damaged, lost hose clamp, hose,
pipe, oil cooler and its flange bolt, do not
bend or hit high-pressure hose, do not install
twist or damaged hose or piping.
4.5.2 Maintenance in running-in period.(the first
50 hours)
4.5.2.1 Replace engine oil, oil filter.
1) Start engine to warm up oil without
overheating.
2) Lower bucket to ground, stop the
machine at level ground. Turn off
auto-idle switch to run machine
unloaded at low speed for 5 minutes.
【Important】
Stopping engine improperly can cause
damages to turbocharger.
3) Set starting key to OFF position, stop engine,
remove the key from starting lock, set pilot
safety lock lever to LOCK position.；
4) Open bottom cover underneath engine, place
container under drain valve of engine oil pan.
Open drain valve to drain engine oil.
Note
The engine oil might be hot, be care to
handle it without being burned.
5) With engine oil drained, fasten and secure
drain valve.
To Next Page
Loading...
