OPERATION & MAINTENANCE MANUAL SWE50E/SWE60E/SWE70E/SWE80E9/SWE100
Replace engine oil filter
1) Oil filter is positioned on the engine.
2) Use special wrench for filter to remove
with anti-clockwise
3) Use special wrench for filter to rotate
cartridge clockwise for 3/4 or 1 turn.
Pay attention not to over fasten.
Replace engine oil
1) Fill with oil through oil fill cap and
check oil fill volume until specific scale
position on dipstick is reached.
2) Cap oil filling port.
3) Start engine; run it unloaded at low
speed for 5 minutes.
Check engine oil pressure indicator (red)
on monitor to make sure it goes off. If
it’s still on, stop engine immediately
and identify the cause.
Check drain valve for any leakage.
Check dipstick for oil level.
To Next Page
Loading...
