OPERATION & MAINTENANCE MANUAL SWE50E/SWE60E/SWE70E/SWE80E9/SWE100
(c) Heating Operation
At first, the hot water valve must be opened, then do according “aeration operation”.(Figure
2)
3.8.3 Special operations
(1) Strong refrigeration operation
When it is very hot, especially a period of time after just turning on the air conditioner, you
should choose this operation. That is: choose refrigeration pattern, press “wind speed increasing
button” to choose the highest wind speed, press “set increasing button” to choose the lowest
temperature.
(2) Weak refrigeration operation
When it is slightly hot, especially the period of time after turning on air conditioner, the indoor
temperature is suitable or even a little cool, you should choose this operation. That is: choose
refrigeration pattern, press “wind speed decreasing button” to choose the lowest wind speed,
press “set decreasing button” to choose the highest temperature.
Figure 2 warm water valve
When it is not too hot, after refrigerating for some time, if you feel too
cold, you can counter-clockwise turn the main switch to some proper
degree for lower temperature. After some time, if you feel too high wind
speed, you can lower it by the wind speed switch.
To Next Page
Loading...
