SUNWARD SWE50E - Safety Maintenance Rules

OPERATION & MAINTENANCE MANUAL SWE50E/SWE60E/SWE70E/SWE80E9/SWE100
40
1.4.3 Safety maintenance rules
 Understand all maintenance instructions prior
to operation.
 Keep the working site clean and dry.
 Do not spay water and vapor in cab.
 When the machine if moving, do not lubricate
the machine or perform any maintenance
operation.
 Prevent any parts of the body from reaching
moving parts of the machine.
 If the maintenance procedure has to be carried
out when engine is running. Position a person
in operator seat to stop the engine at any
moment. All persons keep each other in touch.
 Do not operate under the machine which is
supported by boom. If you have to service the
machine with boom supported, use bracket or
block strong enough to support the machine
and working device securely.
 Dispose of replaced parts in time; remove any
accumulated lubricating grease, oil or debris.
 Always disconnect negative terminal from
battery before testing on electrical system or
welding on the machine.
 Provide complete lighting device for jobsite.
When working under the machine or inside the
machine, always use maintenance work light
with protective hood. Or broken bulb pieces
may ignite flammable fluid e.g. spilled fuel,
engine oil, anti-freezing fluid etc.
 Do not make contact with coolant, in case of
contact; there may be some hazards of
blindness, for the skin, cold injury may occur.
 When using pressed air to clean up, injury or
damage can occur due to flying-out particles.
When using pressed air to clean up filter core
or radiator, always wear goggles,
dust-preventive mask, gloves and other
protective items.