SUNWARD SWE50E - Safety Rules During Traveling

OPERATION & MAINTENANCE MANUAL SWE50E/SWE60E/SWE70E/SWE80E9/SWE100
33
1.3.11 Safety rules during traveling
 During operation of machine, do not operate
exceeding max load capacity or performance to
avoid stall and damage to working device.
 When traveling on flat ground, fold the
working device and keep 400 to 500mm high
above the ground.
 When traveling on rough ground, travel at low
speed. Do not steer sharply， there is a risk of
machine turning over. The work device may hit
the ground and cause machine to lose its
balance or damage the machine or structures.
 When traveling on rough ground or on slope,
disable the auto-reduction switch( if present)，
if auto-reduction switch is on, engine revs may
increase. This may cause machine to speed up
abruptly.
 Avoid traveling on obstacles if possible. if the
machine has to travel on obstacles, lower the
working device close to the ground at low
speed. Do not travel over obstacles which
involve risk of tilting machine to one side.
 When traveling or operating, keep a safe
distance from people, structure or other
machine to avoid making contact with them.
 When passing over bridges or structures, check
first structure is strong enough to support the
weight of the machine. When traveling on road,
contact relevant authorities and follow there
instructions.
 When operating in tunnel, under bridges, under
electric wires or other height-limited area,
operate slowly and pay much attention not to
hit anything.