Svantek SV 977D User Manual

160
SV 977D User Manual
Method
Method of the RT60 calculation: Decay (Interrupted
Noise Method) or Impulse (Impulse Response Method).
The selection of the method depends on the used type of
the sound source.
Chapter
12.2
Appendix E
Impulse
Method of RT60 calculation that uses the impulse sound
source (like pistol shot, petard explosion).
Chapter
12.2
Appendix E
Decay
Method of RT60 calculation intended for measurements
when room is excited by broad or narrow band sound
noise source (usually pink noise).
Chapter
12.2
Appendix E
Octave
Type of spectrum (1/1 octave or 1/3 octave) based on
which the RT60 analysis is performed.
Chapter
12.2
Appendix E
Freq. Range
Frequency range for RT60 calculations: 63Hz-4kHz (7
bands) and 63Hz-16kHz (9 bands) for 1/1 octave; 50Hz-
5kHz (21 bands) and 50Hz-20kHz (27 bands) for 1/3
octave.
Chapter
12.2
Appendix E
Recording Time
Time of measurement data (sound pressure level decay
curve) registration during RT60 calculations: 1s .. 30 s.
Chapter
12.2
Appendix E
Time Step
Time-step of data registration (sound pressure level) in
the file during RT60 calculations: 2, 5, 10, 20, 50,
100 ms.
Chapter
12.2
Appendix E
Averaging
Process of averaging of the reverberation time results
from several measurements during RT60 calculations.
Chapter
12.2
Appendix E
Smoothing
Process of smoothing of the raw reverberation time
results. This is used for better visualization of the RT60
results. The value of this parameter means number of
samples taken into consideration by the smoothing
algorithm. The higher is this number the smoother is a
graph.
Chapter
12.2
Appendix E

Svantek SV 977D Specifications

General

Brand	Svantek
Model	SV 977D
Category	Measuring Instruments
Language	English