The Measurement list contains the following positions:
General Settings allowing you to set general measurement parameters,
Measurement Trigger allowing you to set the measurement trigger,
Profiles allowing you to program the profile parameters,
Logging allowing you to program the logging function,
Spectrum allowing you to set the spectrum parameters; this position appears for the 1/1 or
1/3 octave functions,
FFT allowing you to set the FFT parameters; this position appears for the FFT
function,
RT60 allowing you to set the RT60 parameters; this position appears for the RT60
function,
Tonality allowing you to set up the Tonality parameters; this position appears for the
Tonality function,
STIPA Settings allowing you to set the STIPA parameters; this position appears for the STIPA
function,
Ambient noise allowing you to set the ambient noise levels; this position appears for the STIPA
function,
Compensation allowing you to switch on the required compensation filter,
Range allowing you to select the correct measurement range,
RPM Measurement allowing you to set the RPM measurements parameters,
Exposure Time allowing you to set the daily exposure time for dose measurements,
Statistical Levels allowing you to define 10 statistical levels,
Timer allowing you to programme the delayed start timer,
Alarms allowing you to check the status of the advanced alarm function; this position
appears if the ALARM.SVA file is uploaded to the predefined SYSTEM
catalogue.
To Next Page
Loading...
Need help?
General
