Power saver
The saving of the internal source of the instrument’s power can be achieved
by reducing the brightness of the screen when possible.
There are two options for the power saver function. The screen may be
switched off (Screen off on idle) and/or dimmed (Dim screen on idle). When
either of these options are set, after a delay from pressing any key, defined by
the parameters Dim screen delay or Screen off delay, the screen is dimmed
or switched off. If it has happened, the first press of any key will cause the
screen to switch back on again.
Power saver delay
The power saver delay defines the delay period from the last use of any key to
the power saver mode. This delay period can be set for Dim screen on idle
from 5 s to 60 s and for Screen off on idle from 1 m to 60 m. The <ENTER>
key must be pressed for confirmation of the selection, which then also closes
the Screen Setup screen.
5.5 CUSTOMIZING THE COLOUR THEME OF THE DISPLAY – THEMES
The Themes screen allows you to set the
colour theme of the display.
It is possible to choose between Dark and
Light themes. Dark theme is presented in this
Manual.
The Light colour theme uses more energy.
To Next Page
Loading...
