Bottom Dead Point Stop
It sets the needle bar to stop at the lower dead stop after completing the embroidery.
- Basic setting is NO. To use this function, select “1” for YES.
Frame Setting
It sets the type of frame to be used.
-
The default value is “FLAT(0)”. When trying to activate CAP, enter “1”. After CAP is activated, new design is
automatically set to have 180° revolving angle when it is called.
Frame Speed Setting
It sets the speed of frame movement such as automatic return to origin and offset movement.
- The default is “High Speed (1)”. When desiring to change it to low speed, press “0”.
Frame Move Method After (Trimming)
It sets the function, which moves the frame left and right after trimming in order to separate thread from the
embroidery material.
- Basic setting is X (1) axis. To select the direction of Y (2) axis, input “2”. If you do not want to use this
function, select NO (0).
Inching Stitch
The machine slowly inches at the start of the embroidery. It sets the number of stitches to be inched.
- Basic setting is 2 stitches and you can set it in the range of 2~10 stitches in the unit of 1 stitch.
Needle Move Function (Offset)
When the needle moves to the offset position, it activates the jump motor to lift the needle bar.
- Basic setting is YES (1) and you can select NO (0).
Power ON Auto Origin
It sets the machine to automatically return to the origin point after turning on the power.
- Default is “NO.” If you selected “YES” but do not want the automatic return function due to incorrect origin
setting or machine malfunction, you must initialize all settings. For initialization, refer to ‘3.1.3 Memory - (2)
Para Init’.
START/END Filter
It sets whether or not to use the function of automatic filtering stitches shorter than 0.5mm at the start and the end
of the embroidery for prevention of thread breaks.
- Basic setting is “0.0[mm]”and you can set it in the range of 0.1~0.5mm in the unit of 0.1mm.
To Next Page
Loading...
