Press .
[Ex.5.9.4-5] SELECTING ALL NEEDLE BAR PRESSER FOOT HEIGHT
Setting the presser foot height of all needle bars at 2.5mm.
Perform [Ex.5.9.4.-1]
The needle bar's presser foot height is set at 1.0mm as default.
Press the Needle Height button.
When the Needle Height button is pressed, EACH, ALL buttons are activated accordingly.
EACH button is selected as default, and then press ALL.
Use the number keypad and press 5 among numbers 1 to 9.
As illustrated in <Fig. 5.9.4-17>, the presser foot height of all needles have been changed to 2.5mm.
[Fig.5.9.4-17]
To Next Page
Loading...
Need help?
General
