Station Features 100 FlexSet 120S/280S User Guide
Group Calls: Adding Participants
Group Calls: Adding Participants
Allows an authorized user to transfer a new participant to an established conference. The feature enables a user
engaged in a conversation to add his conversing party to the ongoing conference. The feature can be enabled when
the Group Call is not locked against non-registered participants, and connecting to the ongoing conference is not
restricted.
Adding an additional participant to an ongoing Group Call:
While connected to a station/trunk:
1. Press [Xfer].
2. Listen for the dial tone
3. Press the lit Group Call DSS key or dial the Group Call access code.
A warning tone will be heard by all participants (if defined system-wide).
4. Both the new participant and yourself are connected to the group call.
NOTES:
1) When the group is defined as locked against non-registered participants, and one of the conversing parties is not
registered, the reorder tone is heard and the CNF LOCK message is displayed. The registered party joins
successfully, while the non-registered party is disconnected. If neither are registered members, both conversing
parties will be disconnected.
2) When the group is defined such that no new participant can join an ongoing conference, both conversing parties
will be disconnected. The busy tone is heard and the BUSY message is displayed.
To Next Page
Loading...
