Station Features 130 FlexSet 120S/280S User Guide
Page Queue
Page Queue
Use Page Queue to send or retrieve a call to/from a Page Queue destination. After sending a call to Page Queue x,
your FlexSet is then freed to page all system members to announce there is a call on line x. The party put on hold
may hear one of the following: music, recorded tone, busy tone or no sound at all, as defined system-wide for each
Page Queue.
Press [Page_Q] to access the Page Queue options.
10:50 26 May 2004 site name
user name station number
Redial Page_Q Hold Remind PickUp
10:50 26 May 2004 site name
user name station
Page_Q Hold Remind
Page 1
Page_Q Place/Pickup Call
PageQ1 PageQ2 PageQ3 PageQ4 PageQ5
Page_Q Place/Pickup Call
PageQ1 PageQ2 PageQ3
Page 2
[PageQ
x
] While on a call, press [PageQ
x
] (x = 1 to 10) to send the call to Page Queue number x, where x is a parked
station or trunk.
To pickup a queued call, press [PageQ
x
] to retrieve the call from Page Queue number x.
You can pick up the call from any station by selecting the relevant Page Queue number.
If the call is not picked up within a predetermined time, it will automatically return to the originating station from
which Page-Queue was placed. Press
SPKR or pick up the handset to answer.
NANS page Q dial# 2nd party
DND Mute FwdAll Number
NANS page Q dial# 2nd party
DND Mute FwdAll
To Next Page
Loading...
