Tadiran Telecom FlexSet 280S - Station Setup Features

Attendant Features 194 FlexSet 120S/280S User Guide
Station Setup Features
Station Setup Features
The Station Setup Features menu allows an attendant to define stations for specific feature activation. Some of these
features operate permanently, or until redefined. Other features operate on a one-time basis; after the feature is
activated, it is then cancelled and must be redefined or reactivated in order to operate again.
Press [St.Set] to access the Station Setup Features.
10:50 26 May 2004 site name
user name station number

BG:Fwd aFwd Charge St.Set Tk.Set
10:50 26 May 2004 site name
user name station

aFwd Charge St.Set
Page 1
Station Features - Setup

ChkI/O DND HotDly HotImm OrgOnl
Station Features - Setup

ChkI/O DND HotDly
Page 2
♦ [ChkI/O] Check In/Check Out enables certain activities to be performed automatically (primarily used for
rooms/stations). These are: Room Block/Unblock, Charge Print, Canceling Existing Messages and
Terminating DND. Additionally, if defined system-wide, Wakeup and Call Forward are cancelled and
Charge is reset. In some systems (defined system-wide) this feature can be activated only on idle
stations. If an attempt is made to activate the feature on a busy station, the BUSY message is displayed.
♦ [DND] Do Not Disturb (DND) is used to activate Do Not Disturb for a station or boss group. A caller to this
station will hear a reorder tone, and only a station with DND override is able to call that station.
 [HotDly] Hot Station Delay is used to program a telephone to ring another station, automatically connect to a
paging device, or automatically dial out when the handset is taken off-hook, or
SPKR is pressed, and no
digits are dialed within the programmed first digit time-out. Possible destinations are operator, station,
hunt group, boss group, keyset voice page, zone group page, page public address, UNA/central bell,
outside trunk call, public and private speed dial, pre-recorded DVMS message, group call, and network
number.
 [HotImm] Hot Station Immediate is used to program a telephone to immediately ring another station,
automatically connect to a paging device, or automatically dial out immediately when the handset is
taken off-hook, or
SPKR is pressed. Possible destinations are operator, station, hunt group, boss group,