Attendant Features 195 FlexSet 120S/280S User Guide
Station Setup Features
keyset voice page, zone group page, page public address, UNA/central bell, outside trunk call, public
and private speed dial, pre-recorded DVMS message, group call, and network number.
♦ [OrgOnl] Originating Only is used to prohibit incoming calls from arriving at a station. In this case the user can
only make outgoing calls, but is unable to receive calls. A caller to this station will hear the reorder
tone.
♦ [Rstrct] Outgoing Call Restriction is used to prevent a station from making outgoing trunk calls.
♦ [Block] Station Blocking is used to temporarily prevent a station from both making and receiving calls. A caller
to this station will hear the reorder tone.
♦ [TrmOnl] Terminating Only is used to prohibit a station from originating any telephone calls (internal or
external). When defined as Terminating Only, the user can receive calls, but is unable to make calls.
Operating features marked with ♦ (Above):
1. Choose the required feature option ( [ChkI/O], [DND], [OrgOnl], [Rstrct], [Block], or [TrmOnl] ).
2. Press [St/Rm#] and dial a station/room number, or scroll through the list using
.
3. Choose [Set] to activate (ASSIGN message appears), OR
Choose [Cancel] to deactivate (DEASSIGN message appears).
NOTE For [ChkI/O], [Set] activates Check Out and [Cancel] activates Check In.
4. Press [Exit] or the
SPKR key to exit.
Operating features marked with (Above):
1. Choose the required feature option ( [HotDly] or [HotImm] ).
2. Press [St/Rm#] and dial the originating station number, or scroll through the list using
.
3. Choose [Dest] and dial the destination number, OR
Choose [Cancel] to cancel feature.
4. Press [Exit] or
SPKR to exit.
To Next Page
Loading...
