Tadiran Telecom FlexSet 280S - Account Code

Station Features 49 FlexSet 120S/280S User Guide
Account Code
Account Code
An account code can be entered before or during an external (incoming or outgoing) call, causing the call to be
marked with the account code on the SMDR (Station Message Detailed Records) printout.
Depending upon your system definition, up to 16 digits are available for account numbers. Only one account number
entry is allowed for a single call. Any additional number show the message “ALREADY SET”. Should you dial a
wrong account number (when VFAC is installed in your system), the error message “PASSCODE FAIL” appears.
Press [AcctCd] to enter the Account Code.
10:50 26 May 2004 site name
user name station number

AcctCd IDCtrl WakeUp CnfIns GpCall
10:50 26 May 2004 site name
user name station

WhspPg SltMon AcctCd
Page 1
ENTER ACCOUNT #
A
CCOUNT NUMBER
* * * * * * * * * Enter Destination * * * * * * * * * *
ENTER ACCOUNT #
A
CCOUNT NUMBER
* * * Enter Destination * * *
Page 2
Activating during external call:
1. Press [AcctCd].
2. Dial the relevant account number.
3. Listen for the confirmation tone.
4. Continue with the call or hang-up.
NOTE: Last Number Redial code, Saved Number code or Speed Number can also be used instead of an outside line
where applicable.