Tadiran Telecom FlexSet 280S - Trunk Setup Features

Attendant Features 203 FlexSet 120S/280S User Guide
Trunk Setup Features
Trunk Setup Features
Trunk Controls allow the attendant to define the operation of system trunks for special use, such as for incoming or
outgoing calls only, or for designation of a trunk as reserved for a particular group or specific station.
Press [Tk.Set] to access the Trunk Setup Features.
10:50 26 May 2004 site name
user name station number

BG:Fwd aFwd Charge St.Set Tk.Set
10:50 26 May 2004 site name
user name station

Tk.Set System
Page 1
Trunk Features - Setup

A
utGrd Block BsyOut DIL-D DIL-N1
Trunk Features - Setup

A
utGrd Block BsyOut
Page 2
♦ [AutGrd] Auto Guard is used to view which of the trunks have been automatically blocked from use for outgoing
calls by the Auto Guard feature. When ASSIGN appears in the display the trunk line is blocked.
DEASSIGN means the trunk line is in use by the system. Auto Guard automatically blocks a trunk
when the system detects no dial tone on a trunk.
When a trunk is Assigned (Blocked):
When a trunk is in ASSIGN status (blocked), cancel the Auto Guard as follows:
1. Choose [AutGrd].
2. Choose [Trunk#] and dial a trunk number, or scroll through the list using
.
3. Choose [Cancel] to deactivate (DEASSIGN message appears).
4. Choose [Exit] or
SPKR to terminate.
5. Make an external call on the specific trunk. If the call goes through, the line is okay.
If the trunk is still blocked, call the technician and reactivate Auto Guard, by following steps 1 2
above and choosing [Set] to activate (ASSIGN message appears).