Making Internal Calls 28 FlexSet 120S/280S User Guide
Internal: Upon Hearing Reorder Tone
Internal: Upon Hearing Reorder Tone
After dialing an internal station that is idle, but has been set to Do Not Disturb or UNATTEND, the following features
are available. After dialing a station and receiving a reorder tone, override can be applied by pressing [DNDOvr].
D
ON
T
DIST
called number or name
CampOn
SendCw V-Page Mute Msg.
DON’T DIST called number or name
CampOn SendCw V-Page
[CampOn] Camp On, also known as Call Back. Use this feature to have the system automatically call you back
when the DND destination station is available. (page 74)
[SendCw] Not used during reorder tone.
[V-Page] Voice Page the called party’s keyset station using this feature. Your call is automatically answered and
your voice heard over the called party’s speakerphone after the Voice Page tone stops. (page 132)
[Mute] Mute can be activated during reorder tone so that when the Do Not Disturb is overridden, your side of
the conversation is muted and the called party will not hear anything. When this feature is activated by
the [Mute] on/off toggle switch, a bullet appears. The mute feature deactivates the microphone for your
speakerphone and handset or headset. Press the toggle key again to restore microphone.
[Msg.] Leave Message. Use this feature to leave a “message” at the called party’s station. This feature lights
the message waiting lamp at the called party’s station indicating that a message was left, and it leaves a
simple message such as CALL SUSAN on the destination station’s display. (page 116)
[Brk-In] Break In operates as [DNDOvr].
[DNDOvr] DND Override enables an authorized user to send a ring tone thus overriding the Do Not Disturb status.
When you hear the reorder tone, if DON’T DIST or UNATTENDED message appears, override can be
applied and your call can be put through to the station.
To Next Page
Loading...
