Making External Calls 37 FlexSet 120S/280S User Guide
External: Upon Hearing Busy Tone
External: Upon Hearing Busy Tone
After dialing an external destination, the following features appear on your FlexSet display when you hear a busy
tone. Hang up and dial later or press the nearby soft key to activate the required feature.
OUT trunk line
USER BUSY
Msg. CampOn
utRdl Save#
OUT trunk line
USER BUSY
Msg. CampOn
utRdl
[Msg.] Leave Message is used when dialing network destinations and not external destinations.
Use this feature to leave a “message” at a busy station. This feature lights the message waiting lamp at
the called party’s station indicating that a message was left, and it leaves a simple message such as
CALL SUSAN on the destination station’s keyset display. (page 116)
[CampOn] Camp On, also known as Call Back. Used only when dialing network destinations and not external
destinations. When the network station is busy, you may request that the system automatically call you
back when the required destination number is available. (page 74)
[AutRdl] Auto Redial is used to have the system automatically redial the unanswered destination. Further redial
options are available after activation. (page 149)
1. Press [AutRdl]. The system will now automatically redial at timed intervals.
2. When the called party answers, press the flashing
SPKR or lift the handset to enable conversation.
[Save#] Save Number is used to save the dial number of the busy destination. The saved number can then be
redialed by pressing [Redial] [Saved#] from idle. (page 149)
NOTE: The saved number will remain in memory until another number is saved by repeating the
above procedure.
To Next Page
Loading...
