Tadiran Telecom FlexSet 280S - System Features

Attendant Features 196 FlexSet 120S/280S User Guide
System Features
System Features
The System Controls menu allows the attendant to program certain features for system-wide operations.
Press [System] to access the System Setup Features.
10:50 26 May 2004 site name
user name station number

System
10:50 26 May 2004 site name
user name station

Tk.Set System
Page 1
System Features - Setup

A
larm ATT-To XfrD/N Day/N1 Day/N2
System Features - Setup

A
larm Att-To XfrD/N
Page 2
[Alarm] Alarm is used to identify and examine system alarms.
See the PI & Database Reference Manual for a detailed list of the alarm codes and their definitions.
1. Press [Alarm].
2. Choose [Next] (next alarm) to scroll through the alarm list. The alarm number and its code are listed
on the system lines.
3. Make a list of each alarm number to report to the technician.
4. Press [Exit] or
SPKR to exit.
Alarm message – LED status:
When an ALARM DSS key is programmed (default dial number: #1997), the LED status indicates the
following conditions:
Off: No alarms
Blinking: Alarm condition has occurred
Steady On: Alarm condition remains but has been examined by the attendant.