Station Features 164 FlexSet 120S/280S User Guide
Silent Monitoring
Silent Monitoring
This feature enables an authorized user to monitor and/or record (may require additional hardware) any system port,
station, trunk, etc. in any state (except data and conference), without audio or visual warning to the monitored party.
While monitoring a port, your telephone returns a busy signal for all incoming calls.
The volume can be adjusted using the
buttons whilst monitoring, and you can whisper by pressing [WhspPg].
Press [SltMon] to access the Silent Monitoring options.
10:50 26 May 2004 site name
user name station number
CampOn Park V-Page WhspPg SltMon
10:50 26 May 2004 site name
user name station
WhspPg SltMon AcctCd
Page 1
Silent Monitoring
S.Mon1 S.Mon2
Silent Monitoring
S.Mon1 S.Mon2
Page 2
[S.Mon1] 1-Way Split Silent Monitoring is used to monitor either side of a 2-way conversation separately. Only
one of the conversing parties can be heard at any one time. This feature can be activated from idle only,
as follows:
1. Press [S.Mon1].
2. At the prompt, dial the station number of the original destination (1
st
party), then:
a. To monitor the 1
st
conversing party, choose [Origin].
b. To monitor the 2
nd
conversing party, choose [2ndPrt].
3. To cancel Split Silent Monitor, press [Abort],
SPKR or hang up.
4. To whisper to the 1
st
party, press [WhspPg].
Whispering to the 2
nd
party is not allowed.
NOTE: If you hear the reorder tone when attempting to monitor a call, the port is SECURED against
monitoring.
To Next Page
Loading...
