Attendant Features 191 FlexSet 120S/280S User Guide
Attendant: WakeUp
[Reques] WakeUp Request is used to program a station to ring at a specified time.
Entering a new Wakeup Request:
1. Press [Reques].
2. Choose [St/Rm#] and dial the station/room number, or scroll through the list using
.
3. Choose [Set] to enter a new time for the station/room. The ENTER TIME message appears on the
top line.
4. Dial in the wakeup time.
NOTE Four digits are required for a 12-hr clock: (i.e. 0805 for 8:05).
5. Choose [AM] or [PM].
6. Press [Exit] or
SPKR to exit.
Canceling Wakeup Request:
1. Press [Reques].
2. Choose [St/Rm#] and dial a station/room number, or scroll through the list using
.
3. Choose [Cancel] to delete the time.
4. Press [Exit] or
SPKR to exit.
[Report] WakeUp Report is used to print the wakeup requests that were not answered. The report may be sorted
by the requested wakeup time, or by the station number, as defined system-wide.
1. Press [Report].
2. The WAKEUP REPORT message appears on the top line of the display.
3. Listen for the confirmation tone. The printer automatically prints the report.
To Next Page
Loading...
