Attendant Features 205 FlexSet 120S/280S User Guide
Trunk Setup Features
♦ [HotImm] Hot Trunk Immediate is used to program an outgoing trunk so that the trunk automatically and
immediately connects to the system.
♦ [HotDly] Hot Trunk Delay is used to program an outgoing trunk to automatically connect to the system, after
first digit time-out, when no dialing has taken place.
♦ [IncOnl] Incoming Only is used to reserve any trunk for incoming calls only, thereby preventing outgoing calls
on that trunk.
♦ [OutOnl] Outgoing Only is used to reserve any trunk for outgoing calls only. All incoming calls on that trunk
will continue ringing with no answer and will not be transferred to any destination.
[RsvdTo] Reserved To is used to reserve any trunk and trunk group to a specific station or boss group. The
reservation will prevent any other stations or boss group stations from making outgoing calls on these
trunks.
Operating features marked with ♦:
1. Choose the feature soft key ( [AutGrd], [LAR], [Block], [BsyOut], [DropND], [HotImm], [HotDly], [IncOnl], [OutOnl] ).
2. Choose [Trunk#] and dial a trunk number, or scroll through the list using
.
3. Choose [Set] to activate (ASSIGN message appears), or
Choose [Cancel] to deactivate (DEASSIGN message appears).
4. Choose [Exit] or
SPKR to terminate.
Operating features marked with :
1. Choose the feature soft key ( [DIL-D] , [DIL-N1], [DIL-N2], [RsvdTo] ).
2. Choose [Trunk#] and dial a trunk number, or scroll through the list using
.
3. Choose [Dest] and dial the destination number, or
Choose [Cancel] to cancel feature.
4. Choose [Exit] or
SPKR to terminate.
To Next Page
Loading...
