Station Features 69 FlexSet 120S/280S User Guide
Call Forwarding
Internal/External Call Forwarding
In addition to the forwarding options detailed above, your FlexSet can distinguish between calls arriving from an
internal or external source when forwarding. For each forwarding feature (forward all, when busy, on no answer, etc),
you can program your FlexSet to forward your calls as follows:
• Forward Internal and External calls to the same destination
• Forward Internal and External calls to the different destinations
• Forward Internal calls only, while External calls keep ringing at your station
• Forward External calls only, while Internal calls keep ringing at your station
This is demonstrated in the following table using the [FwdAll] and [All-E] feature as an example:
Forward Option Resultant Call Destination Case
[FwdAll] Set To:
[All-E] Set To:
Internal Calls Go To External Calls Go To
1 Cancel (not set) and Cancel (not set) Your Station Your Station
2 Destination X and Cancel (not set) Destination X Destination X
3 Cancel (not set) and Destination Y Your Station Destination Y
4 Destination X and Destination Y Destination X Destination Y
5 Destination X and
Destination Y
(programmed as
Your Station)
Destination X Your Station
Possible destinations for X are: operator, station/group, external number via public and private speed call library,
DVMS pre-recorded message, UNA/central bell, group call, or network number.
Possible destinations for Y are the same as for X, plus your own station number, thus facilitating forwarding of
internal calls to another destination, whilst retaining external calls at your own station, as shown in Case 5 above.
To Next Page
Loading...
