RUN MED: Service & Maintenance Manual - rev. 1.0
Figure 7.17-9
When reassembling the running deck,
remember to insert the plastic bushing
and the washer “k” on the rear
supports.
Figure 7.17-10
l securing the shock
absorbers to the frame using a 4-mm Allen
To disassemble the shock absorbers:
15. Back off the 2 screws
wrench, accessing it from below.
Remember to insert the two spacers “m”
when reassembling the shock absorbers.
Figure 7.17-11
16. Fu
te
17. R
in
18. R the tread belt.
To reassemble the various components, carry out
the above steps in reverse order.
lly back off the screws which release the
nsion of the rear roller.
emove the rear roller from the top as
dicated by the arrow.
emove
At the end of the procedure, check the
alignment of the motor drive-belt, the
tension and alignment of the tread belt
and the height adjustment of the
running deck 8.1. “Tensioning a new
tread belt”, 8.2. “Tensioning a used
tread belt” and 8.3. “Centering the tread
belt”.
Page 7.25
To Next Page
Loading...
