Terumo CAPIOX EBS Circuit with X coating - Page 143

Various menu settings
 Setting the IP address of the Controller
1. Tap [IP] of [Controller]. (Figure 3-106)
The IP (Controller) screen opens.
2. Tap the button of the address value you want to input.
(Figure 3-107)
The following screen examples show when the top button is selected.
Figure 3-106
3. Tap or to input the IP address of the Controller you
want to set. (Figure 3-108)
The input range is 0 to 255.
Figure 3-107
4. Input the values into all of the boxes with the same
operation as in steps 2 and 3. (Figure 3-109)
Figure 3-108
5. Tap [OK] to complete the setting. (Figure 3-110)
Proceed to “Setting the Subnet Mask”.
Figure 3-109
Figure 3-110
• If you do not tap [OK], the changes to the setting will not take effect.
114
Note