Tettex 2293 - Protocol

Remote Control
185
TCP-Port:
50000
or
Address: 132.20.196.55
Subnet: 255.255.0.0
Gateway: 132.20.0.1
22.2 Protocol
The device accepts exactly 1 incoming TCP connection on port 50000 for remote controlling. When a
connection to a client has been established, the device will accept further connections, but it will
immediately close these connections. Commands must be sent as TCP data. The protocol stack looks as
follows:
Ethernet
IP
TCP
[Command][?] [Parameter1],[Parameter2],…<CR><LF>