Tettex 2293 - Performing a Test Using Classic Mode; Test Object Connection on Classic Mode; Set up DUT Data; Temperature Correction

Resistance Measurement
67
7.5 Performing a test using Classic mode
Before operating the instrument, make sure that the safety rules have been fully
read and understood. It is the responsibility of the end user to ensure that the
system is operated in a safe manner.
Performing a resistance measurement using classic mode consist of following steps
7.5.1 Test object connection on classic mode
Follow the instructions in the “connection and setup” chapter in this manual.
7.5.2 Set up DUT data
To set up the steps with DUT related data:
 see related chapters in the “User Interface” part.
7.5.3 Temperature correction
The bridge can perform temperature correction for the values measured, as related in the IEC or
other national or international standard.
DUT general data
Selection of the
corresponding DUT
main parameters
Material selection
Configuration of the
automatic
temperature
correction
Selection of the
desired test current
Auto recording
selection
Measuring
Exporting and
printing results