The system has 7 programmable messages.
1 - Reset Message
This 32-character message is displayed whenever the control panel
requires an Engineer reset.
2 - Anti-code Msg.
This 32-character message is displayed whenever the control panel
requires a Anti-code Reset.
3 - Service Message
This 32-character message is displayed whenever the control panel
requires Daytime reset.
4 - Location Text
This 32-character message is displayed whenever the engineer views
the location text in ‘Engineer Utils’.
5 - Banner Message
This 16-character message is displayed above the time and date
whenever the control panel is unarmed or fully armed.
6 - Part Arm Banner
This 16-character message is displayed above the time and date
whenever the control panel is part armed.
7 - Printer Header
This 16-character header will be printed whenever a log printout is
taken from the control panel or a Short Message Service (SMS) text
message is sent to a mobile phone.
Part Arm Text
Text may be assigned to Part Arm 1, 2 or 3 to allow the user to select
the correct Part Arm by description instead of number. A maximum of
16 characters can be programmed for each of the Part Arms.
The 3 Part Arm messages are global messages and will appear
whenever one of the part arms are selected regardless of which
area is being part armed.
Text is programmed in a similar way to mobile phones. Select
characters by pressing the corresponding key the appropriate
number of times (to select a character on the same key, press
to move the cursor along).