3-27
dummyheaddummyhead
MAINTENANCE
Set the strainer suspension [1] on a new fuel strainer [2]
with the projection [3] up.
Install the strainer suspension by aligning the suction
side joint base [4] of the fuel strainer with the "I" mark
[5] on the strainer suspension.
Install the fuel strainer [1] in harness band clip bracket
B [2].
Connect fuel tube C [3] to the suction side joint [4] of the
fuel strainer and connect the fuel tube [5] to the mark
side [6] of the fuel strainer joint as shown.
Install tube clip B12 [7] with the lugs up.
After connecting the fuel tubes, check for leaking
gasoline from the joints.
Install the engine cover.
[3]
[1]
[4]
[5]
Fuel strainer view from the front:
[2]
To Next Page
