TOHATSU BFT75A - Power Trim;Tilt Switch Inspection (Outboard Motor Side); Trim Angle Sensor Inspection

10-16
dummyheaddummyhead
OTHER ELECTRICAL
POWER TRIM/TILT SWITCH
INSPECTION (OUTBOARD MOTOR
SIDE)
Remove the engine cover.
Disconnect the power trim/tilt switch 3P connector [1].
Attach the tester lead to each terminal and check for
continuity.
When the switch is pushed "UP" or "DN", there should
be continuity between the terminals marked with a
circle in the table below.
TRIM ANGLE SENSOR INSPECTION
Remove the engine cover.
Disconnect the trim angle sensor 3P connector [1].
Measure the resistance between the trim angle sensor
3P connector sensor side terminals.
[1]
Color
Switch position
UP
Neutral
W/Bl
Lg
Lb
DN (Down)
Between Light green/Black and Black 4.0 – 6.0 kΩ
Between Yellow/Blue and Black 2.7 – 4.3 kΩ
[1]